P04654-B21

P04654-B21 is the HPE ProLiant DL325 Gen10 8 SFF CTO Server. The HPE ProLiant DL325 Gen10 Server is the secure and versatile single socket server for virtualization and I/O intensive workloads. This 1P, 1U server delivers and exceptional balance of processor, memory and I/O for 2P performance at 1P TCO. Get the most out of your virtualized environment with this versatile server.

Table 1 shows the quick spec.

Figure 1 shows the HPE DL325 Gen10 server 8SFF Front View – 8SFF + ODD Shown.

Note:

Figure 2 shows the rear view of HPE DL325 Gen10 server.

Configuration Information

This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are ordered, Hewlett Packard Enterprise recommends the use of an HPE approved configurator. Contact your local sales representative for information on configurable product offerings and requirements.

1. Factory Integrated Models must start with a CTO Server.

1. FIO indicates that this option is only available as a factory installable option.

1. All Factory Integrated Models will be populated with sufficient hard drive blanks based on the number of initial hard drives ordered with the server.

1. Some options may not be integrated at the factory. Contact our sales team for additional information.

Step 1: Base Configuration (choose one of the following configurable models)

Step 2a: Choose Required Options – Processors

(only one of the following unless otherwise noted)

Please select one –L21 processor required below.

NOTE: All CTO Models ship with redundant fan configuration.

NOTE: DDR4 memory speed will depend on the quantity and type of DIMMs installed.

NOTE: Processors with greater than 170W will ship with the High Performance heatsink.

Step 2b: Choose Memory Options

Please select one or more memory from below.

Step 2c: Choose Power Supplies

Select one or two power supplies from below.

NOTE: Mixing of 2 different power supplies is NOT allowed.

Step 3: Choose Additional Factory Integratable Options

One of the following from each list may be selected if desired at time of factory integration

Step 4: Choose additional options for Factory Integration from Core and Additional Options sections via datasheet.

Get More Information

Do you have any question about the P04654-B21